What we install
Sinks, faucets, toilets, tubs, showers, utility sinks, washing machine boxes, ice maker lines and outdoor hose bibs are all routine. We also install pressure reducing valves, expansion tanks and whole-home shutoffs. For heaters, see water heater installation.
Each job gets the right shutoff valves, new supply lines and a leak test before we leave. Old parts that fail often, such as plastic supply lines and fixture shutoffs that never close, get replaced rather than reused.
Good times to add or update plumbing
- Before a kitchen or bath remodel closes up walls.
- When you replace a vanity or a tub and the shutoffs are old.
- When you add a bathroom, laundry or wet bar.
- When you buy a house with hard-to-turn valves.
- When a pressure gauge shows high static pressure.
Common installs and what they involve
A short guide to scope.
| Job | What is involved | Planning note |
|---|---|---|
| New faucet | Remove old unit, connect new supplies, test | Confirm the hole count |
| New toilet | Set flange, wax ring, supply and test, see toilet repair | Confirm rough-in size |
| Added shutoff valves | Install under sinks and toilets | Often done with other work |
| New hose bib | Run line, valve and frost-protected spigot | Choose a freeze-proof type |
| Remodel rough-in | Move supply and drain lines | Plan before drywall |
Permits and code in Coppell
Permit requirements depend on the scope of work, so ask the Coppell building department before you start. We install to the plumbing code the city has adopted, and we can tell you in advance whether the job is likely to need an inspection.
You can confirm any contractor with the Texas State Board of Plumbing Examiners public license search. The Responsible Master Plumber number on an estimate is the key to look up.
Plumbing in Coppell's older and newer homes
Much of Coppell was built after DFW Airport opened in 1974 and was fully built out by about 2000. That means many homes have original supply lines and valves that are due for replacement. If you find several worn parts at once, ask about repiping.
Newer neighborhoods such as Cypress Waters have more recent plumbing, so the work there is usually fixture and appliance upgrades. Either way, we check the water pressure first, because high pressure shortens the life of every fixture.
Water treatment and fixtures that go together
Adding a softener or filter often involves new shutoffs and a bypass valve. See water softener and filtration for what that work includes.
Preparing for an installation visit
A little preparation shortens the visit. Clear the area under the sink or around the fixture. Turn on the water at the main valve in the morning so we can test the shutoffs. Have the fixture and its parts unboxed and the instructions handy. If you have the receipt and warranty card, keep them with you.
Tell us about anything unusual, such as a past leak, a remodel that moved plumbing or a fixture that never quite worked. That history saves time because we look in the right place first.
Things that make an installation go smoothly
- Know where the main valve is and that it turns.
- Confirm the fixture fits the space and the hole count.
- Ask whether old parts are being replaced or reused.
- Ask about any permit or inspection for the work.
- Plan for a short water shutoff during the work.
What affects installation pricing
You hear a price before we begin.
Installation is a planned cost and is not covered by insurance.
Sources and where to check
Where this comes from: according to the Texas State Board of Plumbing Examiners, you can verify any plumbing contractor through its public license search. Permit requirements come from the Coppell building department, and the age and build-out facts come from published local history of Coppell.
Planning plumbing work in Coppell?
Call to book a visit and get a clear price.
Plumbing installation questions from Coppell homeowners
Usually yes. We cannot warrant the fixture, only the installation. Check sizing before you buy, or call us first.
Yes, supply and drain lines can be rerouted. Planning before drywall saves cost.
Simple swaps rarely do. Larger changes might. Ask the Coppell building department.
We schedule same-day appointments when we have a truck and parts, and we tell you the real window when you call.
Ready when you are
Call (817) 601-6266 to talk through plumbing installation with a licensed Coppell plumber.
